« previous next »
Pages: [1]

Author Topic: Wanna seal an ELB with tru oil, but I don't wanna seal the horn nocks...  (Read 1614 times)

0 Members and 1 Guest are viewing this topic.

Offline toomanyknots

  • Member
  • Posts: 3,132
Wanna seal an ELB with tru oil, but I don't wanna seal the horn nocks...
« on: September 04, 2013, 10:17:03 pm »
...So I am thinking I am just gonna masking tape off the nocks, and throw a coat on or two and see how it goes. The only thing I am worried about is the finish building up near the tape? Or sealing over the tape, and than pulling some of the finish off with the tape later? Arg...
Logged
"The way of heaven is like the bending of a bow-
 the upper part is pressed down,
 the lower part is raised up,
 the part that has too much is reduced,
 the part that has too little is increased."

- Tao Te Ching, 77, A new translation by Victor H. Mair

Offline JW_Halverson

  • Member
  • Posts: 11,923
Re: Wanna seal an ELB with tru oil, but I don't wanna seal the horn nocks...
« Reply #1 on: September 04, 2013, 10:27:53 pm »
Very little TruOil will soak into the horn, most of it will just wipe off.  What does stick will just close up very small pores and voids. Shouldn't be a problem at all. 
Logged
Guns have triggers. Bicycles have wheels. Trees and bows have wooden limbs.

Offline toomanyknots

  • Member
  • Posts: 3,132
Re: Wanna seal an ELB with tru oil, but I don't wanna seal the horn nocks...
« Reply #2 on: September 04, 2013, 10:41:49 pm »
Quote from: JW_Halverson on September 04, 2013, 10:27:53 pm
Very little TruOil will soak into the horn, most of it will just wipe off.  What does stick will just close up very small pores and voids. Shouldn't be a problem at all.

Okee dokey, :). Guess Ill go tapeless than, cool.
Logged
"The way of heaven is like the bending of a bow-
 the upper part is pressed down,
 the lower part is raised up,
 the part that has too much is reduced,
 the part that has too little is increased."

- Tao Te Ching, 77, A new translation by Victor H. Mair

Offline osage outlaw

  • Member
  • Posts: 11,962
Re: Wanna seal an ELB with tru oil, but I don't wanna seal the horn nocks...
« Reply #3 on: September 04, 2013, 11:12:00 pm »
You could buff the horn after each coat with very fine steel wool.  You will remove anything that doesn't soak in.
Logged
I started out with nothin' and I still got most of it left
Pages: [1]
« previous next »