« previous next »
Pages: [1]

Author Topic: hard maple backing strip question?  (Read 1151 times)

0 Members and 1 Guest are viewing this topic.

Offline bushboy

  • Member
  • Posts: 2,256
hard maple backing strip question?
« on: May 24, 2013, 07:06:53 pm »
I have a 62"ttt elm pyramid that I heat treated about 3" of reflex into and a maple backing strip that varies from 1/8 to maybe a little under 3/32".the grain is decent was wondering if that is a bit thin for a 55# bow?thx's bb
Logged
Some like motorboats,I like kayaks,some like guns,I like bows,but not the wheelie type.

Offline Slackbunny

  • Member
  • Posts: 866
Re: hard maple backing strip question?
« Reply #1 on: May 24, 2013, 07:45:52 pm »
1/8 thick is fine. I built a maple backed cherry bow a couple years ago that is 55 pounds at 28 inches, and the maple strip was 1/8 wide. It was better grain that what you have though. 
Logged

Offline adb

  • Member
  • Posts: 5,339
Re: hard maple backing strip question?
« Reply #2 on: May 25, 2013, 12:32:40 am »
It's hard to see the grain well. Almost all my backing strips in ash, maple or hickory are 1/4" thick, or even 3/8" for heavy bows, but if you don't go too heavy, that should be fine.
Logged
Pages: [1]
« previous next »