« previous next »
Pages: [1]

Author Topic: Boo back question  (Read 1218 times)

0 Members and 1 Guest are viewing this topic.

Offline Stickhead

  • Administrator
  • Member
  • Posts: 940
Boo back question
« on: May 17, 2013, 02:55:47 pm »
Hi,

When backing with bamboo, should I sand down the outer layer of the bamboo, or leave it intact?  I'm tempted to sand it down for aesthetics, but not if it compromises the integrity of the boo.

Thanks,
Tom
Logged

Offline Parnell

  • Member
  • Posts: 5,556
Re: Boo back question
« Reply #1 on: May 17, 2013, 03:01:58 pm »
You can sand the rind off the outside -  the waxier stuff.  You don't want to sand the nodes too much.  They'll give way.
Logged
1’—>1’

Offline Del the cat

  • Member
  • Posts: 8,322
    • Derek Hutchison Native Wood Self Bows
Re: Boo back question
« Reply #2 on: May 17, 2013, 03:10:19 pm »
I asked the same Q a while back when I did my first and only boo backed bow (so now, I are be an expert b'aint oi?  ::))
The consensus seemed to be use a scraper, or fine sand paper /wet or dry paper to take off the rind. Just take enough off to get it clean and don't over do it on the nodes.
Del
Logged
Health warning, these posts may contain traces of nut.

Offline Stickhead

  • Administrator
  • Member
  • Posts: 940
Re: Boo back question
« Reply #3 on: May 17, 2013, 03:36:13 pm »
Cool.  That's the plan then.  Thanks, guys!
Logged

Offline DarkSoul

  • Member
  • Posts: 1,315
    • Orion Bows
Re: Boo back question
« Reply #4 on: May 17, 2013, 06:35:17 pm »
Scrape or sand (80-120 grit) the waxy layer off until you reach the streaky fibers underneath. Careful around the nodes; leave them raised.
Logged
"Sonuit contento nervus ab arcu."
Ovid, Metamorphoses VI-286
Pages: [1]
« previous next »