Can i salvage this?

[Bitterguy]

So I was going to make a 66" Molly for my old man's bday but then I decided to flip the board ovver and mark up a 72", I got it all cut to length and then I went in to remove wood from the lever area, using the drawing of the 66" bow on the wrong side cutting into what was the correct bows working limb by a good 5". This left me at 58" ttt and I was wondering since I'm going for a 25-30# @ 25-26" bow cus he's starting to get his old man joints if I could salvage a pyramid bow out of it, it will have a 4" handle 2" long by 2" wide fade and width taper from 3/4 to 1/2" would this work?

[ionicmuffin]

your going to need to give us the wood type. but most likely it will work

[Bitterguy]

Red oak board

[PEARL DRUMS]

Nope. Your first idea is shot. Time for plan B. Keep the length as is. Make the whole thing 1 1/2" wide. Repeat the process you did on your bow again.  Keep in mind this is pushing the limits to the max and a tad past. You really shouldnt draw the bow over 22-23" to be safe. 25-30# max.

[Bitterguy]

Plan B being the pyramid bow? For understanding purposes why am I bringing it down to 1.5"

[PEARL DRUMS]

Skip the pyramid or grip idea. Your going to make the same bow you just did, but scale it down appropriatly. You can figure it out Im sure. Your a bowyer now.

[Bitterguy]

Alright, I was hoping for a different design, but I guess there are plenty mor staves for me to work on haha

[Ifrit617]

To add on to what pearly said, maybe being a little more helpful, still go for the 66" molle, just keep the draw length down to 25" and you shouldn't have any problem.

Jon

[Bitterguy]

To add on to what pearly said, maybe being a little more helpful, still go for the 66" molle, just keep the draw length down to 25" and you shouldn't have any problem.

Jon

To late now haha

[Ifrit617]

Whoops I think I read your first post wrong... Do what pearly said...

JON

[Bitterguy]

So I scaled it down, would the taper starting at 13" from the tip be good?