3 pc BBO Takedown

[Marc St Louis]

Thanks guys.

[acker]

Nice Bow , very good tiller on it .
You have spend lots of hours to make it 
...but the leather work on the handle ,....

[Marc St Louis]

Nice Bow , very good tiller on it .
You have spend lots of hours to make it 
...but the leather work on the handle ,....

We all have our likes and dislikes, I know I have mine as well 

[jeffhalfrack]

 Hey  Marc  I  love this  bow!!  could  you  post  the  riser  dementions I.E. limb pad  angles  lengths  that   is  one  I'd  love  to  try!  JeffW      and  the  leather work,,,,,,,,,,,,,well  next  time,,,,,just  kidding  thanks  I  all  ways  learn  a  bunch  when you  post  JEFFW

[Marc St Louis]

Jeff
The overall length of the riser is 11".  The length of the limb pads is 3".  I don't know what the angle is in degrees.  The way I do it is I measure down the front of the handle, in this case it was about 1/2". then make a mark 3" back and make a line between the 2 points.  I adjust the angle on each bow in accordance with how much reflex the limbs hold after glue up so that I get some tip setback.  The more reflex the limb holds the more angle I can give it, up to a point.  I like to start off with at least 1" of reflex.