« previous next »
Pages: 1 [2]

Author Topic: Lessons learned BBO failure  (Read 5006 times)

0 Members and 1 Guest are viewing this topic.

Offline lesken2011

  • Member
  • Posts: 2,063
  • Kenny
Re: Lessons learned BBO failure
« Reply #15 on: September 05, 2012, 09:41:48 am »
When I did the glue up I used a flat surface and rubber straps. Then I put a 1 inch board under the tip and came in about 1/3 from the tip and clamped it down. You may be right I may be starving the glue line in that area. I think by switching to a gap filling glue and scoring surfaces I may be able to avoid it in the future. As I said, my straight glue ups have been successful so far with the TB products.
Logged
For by grace you have been saved through faith, and that not of yourselves; it is the gift of God, not of works, lest anyone should boast.

Ephesians 2:8-9

Kenny from Mississippi, USA

Offline Tom Leemans

  • Member
  • Posts: 524
Re: Lessons learned BBO failure
« Reply #16 on: September 05, 2012, 11:34:28 am »
That boo looks way too thick. Measure thickness with a caliper from the flat to the crown, instead of edges. 1/8 at the handle, tapering to 1/16 at the tips. I really hope that URAC isn't dead. That stuff is great!
Logged
Pages: 1 [2]
« previous next »