I've done a couple reflex/deflex bows that were so-so and decided to try a short one with a 57.5" slat of some fo the light-density osage I'm always looking for things to use on. Used a couple ripped strips from a 28" hickory board cut off for the backing, capped at the splice on the back. 56" ntn, 52#/27", 1 and 3/16" wide tapering to fairly slim tips, overlaid with brown osage. Handle built up with ipe on belly side, osage and mahogany on back side. Osage cap piece was a little thick I think (3/16") and clamping it on to glue made it wnat to peel off when drawing - explaining the thread wraps here the grip area. 6" between fades, limbs equal length, with handle shaped to be able to grip it lower than center to get the arrow passing through mid point between tips. This is prototype 2, #1 having had the bend too low on limb giving weird drawn profile. I have it lightened up to be a young lady's bow. Put some bend in with heat and then more with glue up form, tips are out about an inch beyond back of handle. Came out pretty good. Rips them off.
Dave
[attachment deleted by admin]