« previous next »
Pages: [1]

Author Topic: Heat Straightening Question  (Read 1691 times)

0 Members and 1 Guest are viewing this topic.

Offline Strongbow

  • Member
  • Posts: 73
Heat Straightening Question
« on: January 25, 2012, 09:35:52 pm »
Got a few arrows in my latest batch that still need a little straightening.  They are finished up with Tru-Oil.  Is it safe to use heat to straighten them?  Thanks
Logged

Offline HickoryBill

  • Member
  • Posts: 785
Re: Heat Straightening Question
« Reply #1 on: January 25, 2012, 10:57:55 pm »
I would use very light heat with finished shafting...Like a blow dryer or a heat gun on a low setting and then you still run the risk of messing up your finish... depending on the shafting material you might be able to generate enough heat from rigorously rubbing the shaft and hand straightening..or just hand strengthening w/o heat.
Logged
"He who hesitates usually misses"
"All you really need to make a bow and arrow are some sticks and a deer carcass"
Bill Stockdill
Clarion County Pennsylvania

Offline Pappy

  • Global Moderator
  • Member
  • Posts: 32,137
  • if you have to ask you wouldn't understand ,Tenn.
Re: Heat Straightening Question
« Reply #2 on: January 26, 2012, 10:32:19 am »
What Bill said,Tru Oil if very flammable.  ;D
   Pappy
Logged
Clarksville,Tennessee
TwinOaks Bowhunters
Life is Good

Offline Strongbow

  • Member
  • Posts: 73
Re: Heat Straightening Question
« Reply #3 on: January 27, 2012, 12:16:26 am »
Well if I use heat the worst that could happen is I end up with fire arrows    ::)
Logged

Offline RBLusthaus

  • Member
  • Posts: 753
Re: Heat Straightening Question
« Reply #4 on: January 31, 2012, 06:09:08 pm »
Not sure if you used any duco, but that stuff will ignite fairly easily - DAMHIKT.

Russ
Logged
Pages: [1]
« previous next »