« previous next »
Pages: 1 [2]

Author Topic: trade point pointers  (Read 4522 times)

0 Members and 1 Guest are viewing this topic.

Offline gstoneberg

  • Member
  • Posts: 3,889
Re: trade point pointers
« Reply #15 on: November 09, 2011, 10:48:58 am »
I cut mine out with an air cut-off tool.  Have to go slow though or it'll overheat the metal.

George
Logged
St Paul, TX

Offline bowtarist

  • Member
  • Posts: 3,503
  • Primitive Archer Subscription Number PM103651
Re: trade point pointers
« Reply #16 on: November 09, 2011, 11:47:13 am »
As said in my earlier post, I use a cold chisel, ballpeen and a good solid hammering surface to cut both circ. saw and bandsaw blades.  Cut big, grind or file to size.
Logged
(:::.)    Osage music played daily. :)

Offline crooketarrow

  • Member
  • Posts: 2,790
Re: trade point pointers
« Reply #17 on: November 11, 2011, 09:20:32 am »
  Saw mill blades are 1095 steel. You can cut them with a hack saw like they are but I aneal them (SOFTEN) Then there's not hardest nor temper left in them then there easer to cut and grind. Then harden and temper after you've cut and shaped them.
 I've made dozzens and dozzens this way. They will get awesomely sharp and hard somewhere around 56 ,57 ROCKWELL hardest. Which is harder to sharpen but stays sharper longer.
Logged
DEAD IS DEAD NO MATTER HOW FAST YOUR ARROW GETS THERE
20 YEARS OF DOING 20 YEARS OF LEARNING 20 YEARS OF TEACHING
Pages: 1 [2]
« previous next »