« previous next »
Pages: [1]

Author Topic: Sealing shafts...  (Read 1557 times)

0 Members and 1 Guest are viewing this topic.

Offline Bryce H

  • Member
  • Posts: 109
Sealing shafts...
« on: September 25, 2011, 10:08:59 pm »
I realize that this isn't exactly primitive, but has anyone used the waterproofing spray that is usually used for workboots to seal an arrow?
Logged

Offline crooketarrow

  • Member
  • Posts: 2,790
Re: Sealing shafts...
« Reply #1 on: September 26, 2011, 09:18:21 am »
   I'm not sure but I think it works on leather by feeling up the pours. It seams it would wear off ( in the target) you'd have to keep adding  as you use the arrow like your suppose to redo boots.
Logged
DEAD IS DEAD NO MATTER HOW FAST YOUR ARROW GETS THERE
20 YEARS OF DOING 20 YEARS OF LEARNING 20 YEARS OF TEACHING

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,618
Re: Sealing shafts...
« Reply #2 on: September 26, 2011, 10:54:05 am »
It would probably repel water but not slow down the moisture absorbsion rate like a good sealer would.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Bryce H

  • Member
  • Posts: 109
Re: Sealing shafts...
« Reply #3 on: September 27, 2011, 09:49:07 am »
Appreciate it. I just had some laying around that I dont use, so the thought crossed my mind.

I'm always looking for multiple uses of things. ;)
Logged
Pages: [1]
« previous next »