I found a place in the pasture to flight test some of the bows I've built. Couldn't figure out how to keep from looking half the day or loosing them. I talked with halfeye, and he suggested painting the white. So I set out Cut 3 cane shafts to my draw length and spraypainted them with appliance epoxy paint. After drying, I fletched them. Since the cane shaft weights were off from each other (20-30 grains) I cut and grounded duplex nail points to match each other. Then epoxied them in. They weigh 422 422 and 423. Going to be shot from the 42# bow I just finished and posted. Hope to get to try them tomorrow.
Shot them this morning.. shot 3 rounds of 3. Took the distances and averaged them out.
The average was 126 yrds the longest was 130 and the shortes 124. Don't know if that's good or not but it was coooollllll doing it