« previous next »
Pages: [1]

Author Topic: nock?  (Read 2543 times)

0 Members and 1 Guest are viewing this topic.

Offline bubby

  • Member
  • Posts: 11,054
nock?
« on: May 09, 2011, 08:21:56 pm »
I normally go the self nock route, but when I use glue on nock's I have trouble with them poping off and was wondering if I wrapped the end of the shaft and part of the nock, soak the wrap in super glue, if ya think this might help, thank's, Bub
Logged
failure is an option, everyone fails, it's how you handle it that matters.
The few the proud the 27🏹

Offline mullet

  • Global Moderator
  • Member
  • Posts: 22,911
  • Eddie Parker
Re: nock?
« Reply #1 on: May 10, 2011, 12:14:34 am »
Self nocks are stronger. The only time I've BLASTED my arm was when plastic nocks broke.
« Last Edit: May 10, 2011, 08:14:14 pm by mullet »
Logged
Lakeland, Florida
 If you have to pull the trigger, is it really archery?

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: nock?
« Reply #2 on: May 10, 2011, 01:19:39 am »
Buddy, rough up the inside of the nocks with sandpaper first. What glue are you using?
  Like Eddie said...self nocks are stronger.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline scattershot

  • Member
  • Posts: 161
Re: nock?
« Reply #3 on: May 10, 2011, 12:51:59 pm »
Also, when you install the glue on nock, twist it as you are putting it on the shaft. That will get rid of any trapped air in the nock, and will make a better bond. I assume you're using Duco?
Logged
"Experience is just a series of non-fatal mistakes"

Offline bubby

  • Member
  • Posts: 11,054
Re: nock?
« Reply #4 on: May 10, 2011, 02:43:02 pm »
yeah I'm useing duco, this is why i like self nock's, they dont pop off, i'll try the sandpaper, already twist them when putting them on,thank's , Bub
Logged
failure is an option, everyone fails, it's how you handle it that matters.
The few the proud the 27🏹

Offline cracker

  • Member
  • Posts: 3,123
Re: nock?
« Reply #5 on: May 10, 2011, 06:48:29 pm »
I always drill a tiny hole in the nock to let the air escape when pushing it down on the shaft.
Logged
If we can't help each other what is the point of being here?
Pages: [1]
« previous next »