« previous next »
Pages: [1]

Author Topic: Bending walnut  (Read 2061 times)

0 Members and 1 Guest are viewing this topic.

Offline Steve Milbocker

  • Member
  • Posts: 447
Bending walnut
« on: December 30, 2010, 03:18:04 pm »
I justed started roughing out a black walnut bow. One limb is straight, the other has a lot of reflex. Can I heat bend and either add reflex to the straight limb or visa versa or should I just leave it be and try to tiller accordingly?
Logged
I'm no where near as smart as my phone!

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Bending walnut
« Reply #1 on: December 30, 2010, 03:36:11 pm »
I'm not sure about BW. I think if you get it bending a bit as it is then add even reflex to both limbs with dry heat you could temper the belly a little to improve the compression of the BW.   Just a guess though!
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Steve Milbocker

  • Member
  • Posts: 447
Re: Bending walnut
« Reply #2 on: December 31, 2010, 10:30:39 am »
I'll give it a try Pat, thank you.
Logged
I'm no where near as smart as my phone!

Offline Steve Milbocker

  • Member
  • Posts: 447
Re: Bending walnut
« Reply #3 on: January 01, 2011, 05:26:56 pm »
I decided to try steam instead.I'm not as scared of steam than I am of dry heat, besides using the women's corn pot and a little tin foil was way cheaper than buying a heat gun  ;D Got it clamped to a 2x4 with a shim to give it a little "extra". We shall see.
Logged
I'm no where near as smart as my phone!
Pages: [1]
« previous next »