Main Discussion Area > Arrows

Compression Block

(1/2) > >>

duffontap:
Has anyone used the compression block from 3 Rivers Archery?  You heat it up and spin your shafting through with a drill to heat-compress your shafting.  I was wondering if you could compress 3/8" shafts down to 11/32?  It's a little spendy, but it would be worth it if it would allow me to compress a full 32nd of an inch.

           J. D. Duff

mullet:
  You beat me to it JD.I was just looking at that in the cataloge last nite.

duffontap:
I really need to add some weight to my shafting but I like using Doug Fir.  I thought the compression block may be a good option for me if it will allow me to compress the shafting enough.  I may have to switch to Hickory shafting with some of the bows I'm shooting to keep around ten grains per inch. 

         J. D. Duff

Justin Snyder:
You can soak them in danish oil to add a little weight.  I think it adds about 50 grains max.  Justin

jamie:
jd if you do use it you need to up your spine about 5 lbs. if i remember the last time i used one it was set up for 23/64 to 11/32 and 11/32 to 5/16th. an easier way is to use gasket laguer. each coat adds 10-12 grains depending on if its new or been in the tube. i dont reccomend really going crazy with the laquer. but up to 5 -6 coats doesnt hurt and you could use it to dial in the weight of your shafts. im able to get my shafts within +-5grains.

Navigation

[0] Message Index

[#] Next page