« previous next »
Pages: [1]

Author Topic: working recurve  (Read 1633 times)

0 Members and 1 Guest are viewing this topic.

Shadow Walker

  • Guest
working recurve
« on: September 12, 2009, 01:55:20 pm »
O.K, I've done a search on here and I can't find what I'm looking for.
I want to make an iron wood recurve with working limbs. When I tiller the bow, do I need to get the recurved section of the limbs working first and then tiller the rest of the limbs?
Any advice would be greatly appreciated.
Logged

Offline Josh

  • Member
  • Posts: 3,367
  • Silence is golden but duct tape is silver.
Re: working recurve
« Reply #1 on: September 12, 2009, 02:38:51 pm »
I would try and get the mid-limbs and the recurves working all at the same time.  If you get either the recurves or the working limb section working before the other, it seems that part of the limb would be taking too much stress before you are able to get the other sections working.  Just my opinion.  Good luck!    :) -josh
Logged
“The trouble with quotes on the Internet is you never know if they are genuine.” —Abraham Lincoln

Offline Dano

  • Member
  • Posts: 1,349
Re: working recurve
« Reply #2 on: September 12, 2009, 02:48:31 pm »
From my experience, it is better to get the recurves bending first, other wise your midlimb takes all the stress and usually all the set. I put my bow in a vice and taught them to bend by hand, trying not to put any pressure on the limb.
Logged
"If the women don't find you handsome, they should at least find you handy."


Nevada
Pages: [1]
« previous next »