« previous next »
Pages: [1]

Author Topic: selfbow form  (Read 2588 times)

0 Members and 2 Guests are viewing this topic.

Offline dinorocks

  • Member
  • Posts: 59
selfbow form
« on: March 14, 2009, 12:34:53 pm »
Hi All-

Thanks for reading my question.

I would like to remove some twists and put a reflex into an Osage selfbow I'm making.  The bow is now at the floor tillering stage.  Can someone help me with some dimensions for making a form for bending my bow using a heat gun?  I'm assuming I could make the form with a 2x4 or 2x6...  I'm new to this and any guidance would be greatly appreciated!!

Thanks,
Dino
Logged
"Speedy arrow, sharp and narrow"  GD

Offline DanaM

  • Member
  • Posts: 9,211
Re: selfbow form
« Reply #1 on: March 14, 2009, 12:44:37 pm »
Logged
"Prosperity is a way of living and thinking, and not just money or things. Poverty is a way of living and thinking, and not just a lack of money or things."

Manistique, MI

Offline Hillbilly

  • Member
  • Posts: 8,248
  • I like tater tots.
Re: selfbow form
« Reply #2 on: March 14, 2009, 12:45:41 pm »
I made mine from a 2x6. No real science to it. Make it however long your longest bow is likely to be. Leave a flat spot for a few inches in the center and make it a gentle curve from the center to the ends. Drill some holes through it for clamps. About 3" of reflex in the form is good-you'll lose some when you unclamp it and probably wind up with around 2".
Logged
Smoky Mountains, NC

NeolithicHillbilly@gmail.com

Progress might have been all right once but it's gone on for far too long.

Offline Kegan

  • Member
  • Posts: 2,676
Re: selfbow form
« Reply #3 on: March 14, 2009, 09:10:11 pm »
Get a 2x4, and some scraps of wood. Clamp it belly up, and place the blocks where needed to get the deisred shape. best part, you can use ot for straihtenning, reflex, R/D, anything :).
Logged
Pages: [1]
« previous next »