Main Discussion Area > HowTo's and Build-a-longs

New tillering tool

(1/4) > >>

chuck:
Guys i thought I would share this with yall. I have a 6'' X 1'' peice of wood. I drilled a hole in the middle and inserted a short pencil with the tip barley sticking out. As you slide it up and down the limbs you  can see the high and low spots. I have done two bows that way and it cuts back on the hinges. I saw this on a site a while back and if you hadn't tryed this it works good. Good luck hope I helped someone Chuck

DBernier:
Great idea Chuck and a heck of a lot cheeper than my Vernier.  :o  It works real good.

Dick bernier

Pappy:
Chuck I seen the same thing on Trad gang,Eric Krewson a boyer from Alabama put it on a thread.
I have been meaning on trying it but clean forgot about it,glad you brought it up.I am going to give it a try.
   Pappy

El Destructo:
I must be addle Brained...cause I cant picture this at all....can you draw me a Picture...or take one????  I am serious...I am way visual when it come to understanding...I have to see!!!

chuck:
I wil try to find the web site where the tool is pictured. Chuck

Navigation

[0] Message Index

[#] Next page