This is a little bow I started working on at Pappys back in November. It's 60" ntn and about 1-3/8" wide. It has a couple thin courses of sinew on the back, covered with one timber rattler skin split down the middle. The overlays are deer horn and the handle wrap is hemp twine soaked in epoxy.
It draws 49 @27" and shoots good.
I had this thing tillered out to 53 @27", but noticed a few small chrysals on the top limb just above a knot.
So I re tillered it to bend a little more just above and below the chrysals. They don't seem to be getting any worse, but they're there all the same. Saw Filer
[attachment deleted by admin]